Rockwell Automation Logix5000 Controllers Ladder Diagram Programming Manual - Manual (Page 18)

Chapter 1 Program ladder diagram
Choose a name or an existing tag
1. Double-click the operand area, and then click .
The Tag Browser window appears.
2. Select the name or tag:
To select a: Do this:
Label, routine name, or similar
type of name
Click the name.
Tag Double-click the tag name.
Bit number A. Click the tag name.
B. To the right of the tag name, click .
C. Click the required bit.
3. Press the Enter key or click a different spot on the ladder diagram to close
the Tag Browser.
Drag and drop a tag from the Tags window
1. Find the tag in the Controller Tags or the Program Parameters and Local
Tags window.
2. Double-click the tag to select it.
3. Click and drag the tag to its location on the instruction. A green dot appears
to show you where you can drop the tag.
Assign an immediate (constant) value
1. Click the operand area of the instruction.
18 Rockwell Automation Publication 1756-PM008E-EN-P - October 2014