Rockwell Automation 1757-FIM ProcessLogix Fieldbus Interface Module (FIM) Installation Instructions - Manual (Page 6)

6 ProcessLogix Fieldbus Interface Module (FIM)
Publication 1757-IN913A-EN-P - October 2001
3. Align the sides of the module with the chassis guides.
4. Slide the module into the chassis until the module tabs snap into position.
Loading 1757-FIM Firmware
Once the Control hardware is installed and system communications are established,
refer to the Loading CPM Personality Image section in the Startup and Shutdown
Guide in Knowledge Builder, to update the FIM’s firmware. The procedure for
loading the FIM’s firmware is similar to the one used for loading the CPM’s
personality image.
ATTENTION
!
If the FIM is not installed and pre-configured by the factory,
users must load the FIM’s firmware to make it fully
operational. This is also true for any replacement FIM ordered
separately from the factory.
chassis guides