Rockwell Automation 1738-OA2M12AC3 ArmorPoint AC Output Module, Series A - Manual (Page 7)

Publication 1738-IN007A-EN-E - June 2004
ArmorPoint AC Output Module, Series A 7
Wire the AC Output Module Following are wiring instructions for the ArmorPoint AC output
module.
1738-OA2M12AC3
Communicate With
Your Module
I/O messages are sent to (consumed) and received from (produced)
the ArmorPoint I/O module. These messages are mapped into the
processor’s memory. This ArmorPoint I/O output module consumes 1
byte of output data (scanner Tx - status). It does not produce data
(scanner Rx).
Default Data Map for the ArmorPoint AC Output Modules
1738-OA2M12AC3
Message size: 1 Byte
ATTENTION
Make sure all connectors and caps are securely
tightened to properly seal the connections against
leaks and maintain IP67 requirements.
(view into connector)
Pin 1 - Chassis
Pin 2 - L2/N
Pin 3 - Output 0 (M12-A)
Output 1 (M12-B)
43761
7 6 5 4 3 2 1 0
Produces
(scanner Rx) Not Used Channel status
Consumes
(scanner Tx) Not Used Ch1 Ch0 Output state
Where: 0 = off, 1 = on