Rockwell Automation 1783-US8T Stratix 2000 Ethernet Unmanaged Switch Installation Instructions - Manual (Page 11)

Stratix 2000 Ethernet Unmanaged Switch 11
Rockwell Automation Publication 1783-IN010A-EN-P - June 2013
Follow this procedure to connect the power supply to the switch.
1. Disconnect the power terminal connector from the switch.
2. Insert the power wires into the power terminal connector.
To ensure proper polarity of the power wiring, use the cable pinout above, or the
diagram on the switch label.
3. Tighten the power terminal connector by using a screwdriver.
Torque must not exceed 0.5 N

m (4.42 lb

in).
4. Plug the power terminal back into the device.
Be sure the terminal is connected securely.