Rockwell Automation 1738-APB ArmorPoint PROFIBUS Adapter, Series A - Manual (Page 7)

7
Publication 1738-IN015C-EN-E - February 2010
Terminating Bases
Set the Station Address
To set the station address, adjust the switches on the front of the module
(refer to the Module Identification illustration). Use a small blade screwdriver
to rotate the switches. Line up the small notch on the switch with the number
setting you wish to use. The two switches are most significant digit (MSD) and
least significant digit (LSD). Valid address are from 01 to 99. The module
reads the switches only when power is applied.
Set Station Address
43787
Mounting Hole
Latching Mechanism
Ground Connection
31433-M
Station Address Set at 63