Rockwell Automation 1771-DBMEM1,1771-DBMEM2 INSTL.INST EEPROM MEMORY MOD. - Manual

BASIC Module EEPROM Memory
Module
(Cat. No. 1771-DBMEM1, -DBMEM2)
Installation Instructions
Check the contents of the package for.
8K byte EEPROM (1771-DBMEM1) –or–
32K byte EEPROM (1771-DBMEM2)
If any items are missing, contact your local Allen-Bradley office.
Use this publication as a guide when installing this memory module into
the 1771-DB/B BASIC module.
Before you can install the memory module you must remove the 1771-DB
module from the I/O chassis and disassemble the module.
Refer to the BASIC Module User Manual (pub. no. 1771-6.5.113) for
disassembly instructions.
ATTENTION: To avoid damaging the module with
electrostatic discharge:
Wear an approved wrist-strap grounding device or touch a
grounded object to discharge yourself before
handling any equipment. (Note that the wrist
strap is not supplied with the module.)
Do not touch backplane connectors or
connector pins.
If you configure or replace internal components,
do not touch other circuit components inside the module.
When not in use, keep components in a static-shielded bag.
Installation Notes
Before You Begin
17991
Attach this end
to a good earth
ground.