Connect the ascii device, Configure the serial port, Connect the ascii device configure the serial port – Rockwell Automation Logix5000 Controllers ASCII Strings Programming Manual User Manual
Page 10
![background image](/manuals/579884/10/background.png)
Chapter 1 Communicating with an ASCII device
To connect to the ASCII device, use these steps.
1. On the serial port of the ASCII device, determine which pins send signals
and which pins receive signals.
2. Connect sending pins to corresponding receiving pins and attach jumpers.
If the communications
Then wire the connectors
Handshake
Do not handshake
3. Attach the cable shield to the connectors.
4. Connect the cable to the controller and the ASCII device.
To configure the serial port, use these steps.
1. On the Online toolbar, in the controller project, click the controller
button.
2. On the Controller Properties dialog box, click the Serial Port tab.
Connect the ASCII device
Configure the Serial Port
10
Rockwell Automation Publication 1756-PM013D-EN-P - October 2014