Rockwell Automation 1747-PCIS2 PCI Bus Card - Manual

Installation Instructions
Publication 1747-5.31–April 1998
PCI Bus Card for 1746 Local I/O
(Catalog Numbers 1747-PCIS/PCIS2)
Use this document to install and configure the Peripheral Component
Interface (PCI) Bus card for 1746 Local I/O in your personal computer
and connect the card to a Chassis Interface module (1747-PCIL) for
1746 Local I/O. The PCI Bus card works with the Chassis Interface
module and a connecting cable to make up the 1747 PCI Bus Interface.
For additional information on the installation and use of the Chassis
Interface module, see publication 1747-5.32.
In the instructional text of this document, we refer to the PCI Bus card
as the scanner and the Chassis Interface module as the adapter.
We use these conventions in this document:
To install the card, read: See page:
Compliance to European Union Directives 2
Verify Package Contents 3
Installing the Battery and its Connecting Jumper 3
User SRAM 4
Setting the Jumper for Battery Back-Up 4
Setting the Base Memory Address Jumper 5
Accessing the Computer’s PCI Bus Slots 6
Installing the Scanner 7
Selecting the Cable for Your Connections 7
Connecting the Scanner to the Adapter 8
General Operation 9
Calculating Scan Time 9
Troubleshooting 11
Specifications 12
Convention Shows
9 pt Courier bold Text you type as shown at the DOS prompt