Rockwell Automation ControlFLASH Firmware Upgrade Kit User Manual - Manual (Page 41)

Rockwell Automation Publication 1756-UM105E-EN-E - October 2012 41
Appendix
A
ControlFLASH Software Error Codes
Introduction This appendix describes common error messages you may see when running the
ControlFLASH software.
Error Message Description
Log Viewer Error The event log viewer
(Notepad.exe) could not be found Verify that the Notepad application is installed on your system.
Catalog Registry Error The catalog registry database could not be read. Check with your technical
support representative to verify that the correct database is loaded.
Load Driver Error The ControlFLASH software could not find an essential support file for the
selected catalog number. Check with your technical support representative
to verify that the correct drivers is loaded.
Invalid Catalog Number The catalog number of the target device you selected does not match the
catalog number selected in the Catalog Number dialog box.
You selected an incorrect target device or catalog number. Select a device
that matches the catalog number or a different catalog number
Catalog Directory Error The catalog directory database could not be read. Check with a technical
support representative to verify that the correct catalog database has been
loaded.
Invalid Revision The upgrade revision selected is not compatible with the selected target
device. The selected firmware revision is either:
• older than the firmware currently on the target device.
• incompatible with the revision level of the target device.
ATTENTION: Do not continue with the upgrade until you have verified that
the upgrade is compatible with the selected device. Unpredictable system
operation could result.
Instance Validation Error The target device did not report enough information to be properly
identified. Check with a technical support representative for help in
resolving this problem.
Script File Error The script file associated with the selected upgrade is corrupt. Check with a
technical support representative to obtain a new script file.
Data File Error The data file used in programming could not be read. Check with a technical
support representative to obtain a new data file.
Out of Memory Error Your system is low on or out of RAM memory. The ControlFLASH software
could not allocate enough memory for data.
Free up RAM space by:
• Shutting down other applications currently running.
• Increasing the size of your virtual memory.
• Purchasing additional RAM, if necessary.