Rockwell Automation ControlFLASH Firmware Upgrade Kit User Manual - Manual (Page 42)

42 Rockwell Automation Publication 1756-UM105E-EN-E - October 2012
Appendix A ControlFLASH Software Error Codes
Out of Memory Error Log File Error The log file could not be accessed because of a file error. Either the log file
could not be:
• Opened.
• Written to because of an error.
• Written to because the disk is full.
ATTENTION: Check with your application engineer or supervisor before
deleting any files. Verify that you are not deleting any files necessary for
system operation.
If the disk is full, you can free up disk space by:
• Deleting files from your c:\windows\temp directory.
• Uninstalling any unnecessary applications.
• Shutting down and restarting your computer.
Authenticate Error The download restrictions placed on the selected revision could not be
validated. Files containing validation information are corrupted or have been
deleted. Check with a technical support representative for help in restoring
your restriction files.
Restriction System Error The download restriction system could not read the master key disk. Check
with a technical support representative for help in resolving this problem.
RSLinx Load Error An error occurred while the ControlFLASH software tried to install the
network protocol driver (DTL32.DLL). Verify that RSLinx Classic software is
properly installed and configured.
Communication Error An error occurred while the ControlFLASH software tried to communicate
with the target device.
Verify that:
• All cable connections are secure.
• The target device has power.
• RSLinx Classic software is properly configured.
Mode Error The target device is in a mode in which it cannot be programmed. Place the
device into the appropriate mode.
Failed to communicate to the target
device. You do not have the permission
to perform this operation. The error might be caused because that:
• The security authority identifier of the target device does not match the
identifier in FactoryTalk Services Platform. Make sure you have the
permission to perform the operation.
• The slot used for the controller is not a trusted slot. Make sure to use a
trusted slot for the controller.
Error Message Description