Rockwell Automation 1790-XXXX Digital Expansion D-Shell CompactBlock LDX I/O - Manual (Page 4)

4
Publication 1790-IN003A-EN-P - April 2001
Panel Mounting
1. On the panel, position the module next to your
previously-installed module.
2. Gently pull and position the expansion covers inward.
3. Place a center punch, nail or similar device through the
mounting holes in the module (lower left and upper
right corners of the module) and make two marks on
the panel.
4. Remove the module and drill two holes in the panel to
accommodate each of the mounting screws.
5. Replace the module on the panel and place a screw
through each of the two mounting holes. Tighten the
screws until the module is firmly in place.
CompactBlock LDX
1790-16BVO X
EXPANSION UNIT
16 INPUTS-DCPOWER
0
7 0
7
41 mm
1.6 in
95 mm
3.74 in
Expansion
Cover