Rockwell Automation 2711-NP2 Mounting Clips for PanelView 600, 900, 1000 Terminals - Manual (Page 2)

Packing Data
PK
Mounting Clips
(Catalog No. 2711-NP2)
This instruction sheet shows how to install the PanelView 600/900/1000 terminal
in a panel or enclosure using mounting clips (Catalog No. 2711-NP2).
Installation
The mounting clips hold the terminal tightly against the mounting enclosure.
To install the mounting clips:
1. Install the mounting clips on the terminal, the ends of the clips slide into the
slots on the terminal. Tighten the mounting clip screws by hand until the
gasket seal contacts the mounting surface uniformly.
Protective
Installation Label
PV900/1000
Install 6 Mounting Clips:
Top - Left and Right Slots
Bottom - Left and Right Slots
Sides - Left and Right
PV600
Install 4 Mounting Clips
Top - Left and Right Slots
Bottom - Left and Right Slots
Installation Instructions