Rockwell Automation 61C516 AutoMax/AutoMate 24VAC/DC Input Module - Manual (Page 13)

3Ć3
At the time of installation, rotate the keys on the module
and the connector so that they can be connected together
securely. It is recommended that, for modules so
equipped, the keys on each successive module in the
rack be rotated one position to the right of the keys on the
preceding module.
If you use this method, the keys on each connector will be
positioned in such a way as to fit together only with a
specific module, and there will be little chance of the
wrong connector being attached to a module.
Step 7. Turn on power to the system.
Step 8. Verify the installation by connecting the programming
terminal to the system and running the ReSource
Software.
Stop all programs that may be running.
Use the MONITOR I/O function in DCS 5000/AutoMax
systems or POINT MONITOR function in AutoMate
systems.
Toggle each of the input devices connected to the input
module one at a time to verify that the installation has
been completed correctly.
3.3 Module Replacement
Use the following procedure to replace a module:
Step 1.
Turn off power to the rack and all connections.
Step 2. Use a screwdriver to loosen the screws holding the
connector to the module. Remove the connector.
Step 3. Loosen the screws that hold the module in the rack.
Remove the module from the slot in the rack.
Step 4. Place the module in the antiĆstatic bag it came in, being
careful not to touch the connectors on the back of the
module. Place the module in the cardboard shipping
container.
Step 5. Take the new module out of the antiĆstatic bag, being
careful not to touch the connectors on the back of the
module.
Step 6. Insert the module into the desired slot in the rack. Use a
screwdriver to secure the module into the slot.
Step 7. Attach the field terminal connector (M/N 57C370, 61C505,
or 61C506) to the mating half on the module. Make certain
that the connector keys are oriented correctly and that the
connector is the proper one for this module (see step 6 in
3.2 Initial Installation). Use a screwdriver to secure the
connector to the module.
Step 8. Turn on power to the rack.