Rockwell Automation 2193FZ Feeder Circuit Breaker Units Secure Support Pan and ChangeDoor Latch - Manual

Installation Instructions
Feeder Circuit Breaker Units Secure Support Pan and Change
Door Latch
Catalog Numbers 2193FZ
About This Publication This document provides instructions on how to replace the
¼-turn door latch found in the center right-hand side of the unit door, with a new
swing-out latch bracket. These instructions apply only to plug-in Feeder units,
0.5 space factor, that incorporate a 225 A/250 A frame circuit breaker (regardless
of trip setting). This document also covers the addition of fasteners to the
support pans for these plug-in units.
Refer to Figure 1 for a description of the parts of a CENTERLINE

2100 motor
control center section.
This document is intended for 0.5 space factor Bulletin 2193F plug-in units with
a 225/250 A frame circuit breaker.
Required Tools You need the following tools:
• Small flat-bladed screwdriver
• 5/16 in. and a 3/8 in. socket wrench
• Optional, battery operated screwdriver
Topic Page
About This Publication 1
Required Tools 1
Important User Information 2
Before You Begin 4
Secure the Support Pan and Change the Door Latch 4
Remove the Feeder Unit from the Section 4
Remove the Unit Below the Feeder Unit 6
Secure the Support Pans 6
Install Swing-out Latch Bracket 8
Install Units 8
Install New Door Latch Screw and Label 10
Additional Resources 12