Rockwell Automation 2090-U5CK-TB Ultra5000 Connector Kit Installation Instructions - Manual

1 Publication 2090-IN005A-EN-P August 2002
Installation Instructions
Ultra5000 Connector Kit
(Catalog Number 2090-U5CK-TB)
These instructions describe how to wire the I/O connectors for an
Allen-Bradley
® Ultra5000™ Intelligent Positioning Drive. Pinouts for
the I/O connectors on the Ultra5000 drives are provided.
Contents of the Ultra5000
Connector Kit The Ultra5000 Connector Kit includes the following items:
Wiring the CN1A and CN1B
I/O Connectors CN1A (28-pin) and CN1B (14-pin) are plugable, double-row, spring
clamp I/O connectors with 3.5mm spacing. To wire I/O connections:
1. Strip approximately 6 mm (0.25 in.) of insulation from the end of
your I/O wires. Exercise caution not to damage wire strands as you
remove the insulation. Maximum wire gauge for these connectors
is 0.75 mm
2 (18 AWG).
2. With the flat blade screwdriver, depress the
spring clamp next to the I/O pin you are
preparing and insert the wire, as shown.
Note: The connector is keyed by an offset bar on
the drive. Verify proper orientation of the plug
by temporarily attaching it to the I/O connector
on the drive. Always remove the plug before inserting signal wires.
3. After removing the screwdriver, gently pull on each wire to ensure
fastness. Re-insert any loose wires.
Item Description Quantity
1 CN1A - 28 pin I/O connector plug (Weidmueller 174828) 1
2 CN1B - 14 pin I/O connector plug (Weidmueller 174821) 1
3 1/16 inch flat blade screwdriver 1
ATTENTION
!
The Ultra5000 drive contains stored energy devices.
To avoid the hazard of electrical shock, verify that all
voltages on the system bus network have been
discharged before attempting to service, repair or
remove this unit. Only qualified personnel familiar
with solid state control equipment and safety
procedures in publication NFPA 70E, Standard for
Electrical Safety Requirements for Employee
Workplaces, or applicable local codes should attempt
this procedure.