Rockwell Automation 2711E-ND7 PanelView 1200/1400e Transfer Utility - Manual (Page 2)

Publication 2711e-IN001A-EN-P - October 2001 2 PN 41061-267-01(1)
Supersedes Publication XXXX-X.X.X - Month Year Copyright © 2001 Rockwell Automation. All rights reserved. Printed in the U.S.A.
SFU32 (Version 5)
Serial firmware upgrade utility for use with Windows 9x, NT, or 2000
operating systems. To install, run SFU_V5\Disk1\Setup.exe. For
additional information, see Readme.txt in SFU_V5 directory.
SFU (Version 3)
Serial firmware upgrade utility for use with Windows 3.x or 9x
operating systems. To install, run SFU_V3\Disk1\Setup.exe. For
additional information, see Readme.txt in SFU_V3 directory.
Creating a Floppy
Installation Set This CD can be used to create a set of 1.44 MB floppy disks for the
installation of any of the products it contains. Each product is
contained within one of the subdirectories listed below:
•
FTU_V3
•
FTU_V5
•
SFU_V3
•
SFU_V5
To create a floppy installation set for any desired product simply copy
the contents (not the entire subdirectory) of each Diskn (where n is
some number) subdirectory to an empty floppy.
The following commands will create a floppy installation set for the
PanelView e Transfer Utility 32 (FTU), although the drive letters may
differ on your machine.
1. Place empty floppy into drive A.
2. Type xcopy d:\Ftu_v5\Disk 1 a:
3. Remove floppy in drive A and replace with an empty floppy.
4. Type xcopy d:\Ftu_v5\Disk 2 a:
5. Remove floppy in drive A and replace with an empty floppy.
6. Type xcopy d:\Ftu_v5\Disk 3 a: