Rockwell Automation 2755 Decoded Hand-Held Scanner - Manual (Page 95)

Chapter
7
Publication 2755-6.5
Scanner Emulation Cable
(Communication Setup)
This chapter provides the configuration bar codes for the scanner
emulation Synapse cable:
•
(Catalog No. 2755-HFC-SA1-01)
Scanner Emulation Synapse Cable Defaults
Scan the following bar code to set the scanner emulation cable to its
default values. Defaults are indicated with an asterisk *.
Set Scanner Emulation Cable Defaults
Scan this label to set the Scanner Emulation Synapse cable to the default
settings shown below.
Item Default Setting
Code on
Page:
Emulation Standard 7-2
Leading Margin 80 Millisecond 7-3
Decode LED Enabled 7-3
Emulation Timeout 3 Seconds 7-4
Polarity Margin Low / Bar High 7-5
Unknown Characters Send Bar Codes with Unknown Characters 7-5
Convert All to Code 39 Disabled 7-6
Code 39 to Code 39 Full ASCII Disabled 7-6
Parameter Set Parameter Set 1 7-7