Edit expansion i/o configuration – Rockwell Automation 2085 Micro800 Discrete and Analog Expansion I/O Modules User Manual
Page 40
32
Rockwell Automation Publication 2080-UM003A-EN-E - March 2013
Chapter 5 Configure Your Expansion I/O Module
6.
From the Expansion Modules folder on the Device Toolbox pane, drag and
drop 2085-IRT4 on the fourth Expansion I/O slot, next to 2085-IRT4.
After you have added all four expansion I/O modules, your Connected
Components Workbench project should look like this:
The Expansion Modules list should appear as shown below. To see device details
for each of the expansion I/O you have just added, click General. To see default
configuration properties, click Configuration, if available.
Edit Expansion I/O
Configuration
You can edit default I/O configuration through the Expansion Modules Details
box located right below the controller graphic.
TIP
You can edit default configuration by following the procedure provided in
the next section,
Edit Expansion I/O Configuration on page 32
.
Slot 1: 2085-IQ32T
Slot 2: 2085-IF4
Slot 3: 2085-OB16
Slot 4: 2085-IRT4
IMPORTANT
To download configuration to your device, see