Rockwell Automation 6189V-xxxx Non-display Industrial Computers User Manual - Manual (Page 50)

50 Rockwell Automation Publication 6177R-UM002D-EN-P - October 2014
Chapter 4 Component Replacement
12. Disconnect the two SATA cables from the HDD assembly.
13. Remove the PSU.
14. Install the new PSU in the reverse order of the removal steps.
a. Step 11: Torque the five screws to 1.4 N•m (12 lb•in) to secure the
new PSU.
b. Step 4: Reinstall the chassis cross member or I/O card retention
bracket as detailed in Install I/O Card Retention Bracket on page 98 .
c. Verify that all cables are properly connected before you reinstall the
cover.
d. Remove and replace any cut cable ties.
15. Follow the steps for Post-configuration on page 37 .
IMPORTANT Mark each SATA cable so that you can reconnect them to the correct
port after you install the new PSU.