Rockwell Automation 2100M Feeder Circuit Breaker Units Secure Support Pan and ChangeDoor Latch - Manual (Page 10)

10 Rockwell Automation Publication 2100-IN091A-EN-P - April 2013
Feeder Circuit Breaker Units Secure Support Pan and Change Door Latch
3. For all units 1.0 space factor and larger, secure the unit by tightening the
top and bottom captive latches to 22 lb•in (2.5 N•m).
Units that are 2.0 space factors or larger have two captive latches on the top
of the unit and one on the bottom of the unit.
4. Connect the marked unit load wires.
5. Connect the marked control wires.
6. Verify that all power and control wires have been connected properly and
to the proper phases.
Install New Door Latch Screw
and Label
Follow these steps to install the new door latch.
1. On the Feeder unit door, remove the ¼ turn door latch in the upper right-
hand corner of the door.
2. Insert the ¼-20 pan-head screw, with the screw head on the outside of the
door, thru the open hole in the upper right-hand corner of the door.
IMPORTANT Top captive latch must be rotated to vertical and engage behind the front
flange of the unit support pan above the unit.
The bottom captive latch must be rotated to vertical and engaged into the slot
of the unit support pan as shown.
Unit support pan above the unit not
shown for clarity.