Rockwell Automation 8720SM High Performance AC Induction Motors - Manual (Page 4)

Publication 8720SM-IN001A-EN-P — February 2003
4 8720SM High Performance AC Induction Motors
8720SM Receiving and
Storage Information The customer is responsible for inspecting the equipment before
accepting the shipment from the freight company. Check the items
against your purchase order.
Handling
The 8720SM motors are equipped with lifting eye bolts. These eye
bolts are provided to assist in handling and mounting the motors. The
motors can accommodate either flange or foot mount.
Storage
Store motors in a clean, dry area protected from extreme
temperatures, moisture, shock, and vibration. Observe storage
temperatures of -20° to 80° C (-4° to 176° F) with a relative humidity
of 5 to 95%.
The application of motors and other electrical equipment in hazardous
locations is restricted by the National Electric Code. To ensure
compliance, observe these regulations and consult with local code
inspection and enforcement agencies.
ATTENTION
!
Eyebolts may unscrew during lifting. Check the
eyebolts to insure that they are tight. Failure to
observe this precaution could result in bodily injury.
IMPORTANT
All drains are fully operable while in storage. Store
motors so that the drain is at the lowest point. Drains
are located in the lower portion of the motor castings
on both the drive and non-drive ends of the motor.
ATTENTION
!
Only qualified electrical personnel familiar with the
construction and operation of this equipment and the
hazards involved should install, adjust, operate, and/
or service this equipment. Read and understand this
document in its entirety before proceeding. Failure to
observe this precaution could result in severe bodily
injury or loss of life.