Rockwell Automation 6180 Pentium Processors (for 6180 Industrial Computers) - Manual (Page 5)

Pentium
t
Processors 5
To install the processor:
!
ATTENTION: Do not force the processor into the
socket. The processor will only fit in the socket one
way. Refer to the figure on page 3 for proper
orientation. Notice that both the socket and processor
have a flat corner (chamfer) that must be aligned.
1. Make sure the socket locking lever is up. Position the processor
in the socket. Make sure the processor is oriented the same way
as when removed, see page 3. The processor pins will not
completely align with the socket if the processor is not oriented
correctly. The processor fits easily into the socket, do not press
on the processor or bend any pins.
2. Lightly hold the processor in the socket and push down on the
socket lever until it locks in place.
3. Position the heat conductive pad and heat sink on the processor.
The heat sink and pad should be approximately centered over the
processor. Make sure you do not wrinkle or remove conductive
grease from thermal pad.
Note: If the pad is damaged, it cannot be used. Either replace
the pad or use a layer of thermal grease as a substitute.
4. Place the spring clip over the heat sink. Position one end of the
spring clip under the socket tab. Use a needle nose pliers to
position the other end of spring clip under the tab on other side.
On versions with an extended heat sink, insert the spring clip into
the slot on the heat sink first and then into the slot on the opposite
side (see illustration previous page). Be careful not to let the
pliers slip.
5. Secure the power supply with the same screws removed.
!
ATTENTION: Risk of Electrical Shock. Do not use
power supply mounting screws exceeding 0.438 inches
(11.125 mm). Screws that are longer than
recommended may come in contact with voltage
sources within the power supply.
6. Refer to the Processor Board User Manual to check system
jumper settings.