Rockwell Automation 6189V-HPMOUSEP Panelmount Industrial Pointing Device - Manual (Page 5)

5
Publication 6189-IN001C-EN-P - October 2007
Panel Mounting with Mounting Studs
Follow these steps to install the 6189V-HPMOUSEP in a panel using eight mounting
studs.
1. Cut an opening in the panel using the appropriate panel cutout dimensions
provided on page 4.
2. Carefully drill eight 4.76 mm (3/16 in.) holes for the mounting studs as
indicated.
3. Make sure the sealing gasket is properly positioned on the pointing device.
This gasket forms a compression type seal (NEMA Type 4). Do not use
sealing compounds.
4. Place the 6189V-HPMOUSEP in the panel cutout aligning the studs with the
mounting holes.
5. Install the eight self-locking nuts hand tight.
ATTENTION
Disconnect all electrical power from the panel before making cutout.
Make sure the area around the panel cutout is clear.
Take precautions so that metal cuttings do not enter any components that are already
installed in the panel.
Failure to follow these warnings may result in personal injury or damage to the panel
components.