Rockwell Automation 1797-ACNR15 ControlNet Ex Redundant Media Adapter User Manual
Page 15

ControlNet Ex Redundant Media Adapter 15
Publication
1797-5.14 - March 2010
3. Apply +V and -V power to the adapter through a removable terminal
block.
Screw terminals and spring terminals are provided.
4. Strip the +V and -V wires to a length so no bare conductor shows
after inserting the wires into position (+V, -V).
5. If you are using the spring terminals of the plug, insert a screwdriver
into the slot and carefully pry until the spring clamp opens to accept
the wire.
6. Set the network address using the 2-position push-switch G.
Valid settings range from 01 to 99. Press either the + or - buttons to
change the number.
WARNING
Do not remove or replace an adapter when power is applied.
Interruption of the bus can result in unintended operation or
machine motion.
Do not use any unused terminals on this adapter. Using these
terminals as supporting terminals can result in damage to the
module, or unintended operation of your system.
Make certain that you power this adapter with an intrinsically
safe power supply. Do not exceed the values listed in the
specifications for this adapter.
+V -V +V -V
+V -V +V -V
41297