Rockwell Automation 7763 OneGear MV SMC Flex Solid-State Motor Controller - Manual (Page 22)

20 Rockwell Automation Publication 7760-IN001
B-EN-P - June 2013
Chapter 3 Equipment Installation
Locate the cabinetry junction points in the converter cabinet which connect the
converter cabinet with the adjoining switchgear equipment (M10 nuts). Fasten
with M10 hardware at these locations (6 along front, 5 along rear), as shown in
Figure 17 . Repeat operation for joining both switchgear cabinets to the converter
cabinet.
Figure 17 - Junction Point Locations
Rear Junction
Points (x5)
Front Junction
Points inside
LV Panel (x2)
Front
Junction
Points inside
MV section
(x4)