Rockwell Automation 2706-PENET1 InView Ethernet TCP/IP Module - Manual (Page 8)

8 InView Ethernet TCP/IP Module
Publication 2706-IN008D-EN-P - October 2003
Mounting Module to the P72 and P74 Displays
The P72 and P74 InView displays do not have a track for mounting the module on
the display. You can remove the back plate and mount the bottom of the enclosure
to a wall or panel near the display. Use screws (8-32 UNC-2A) measuring a
minimum of 1/4” plus the thickness of the mounting surface.
The dimensions for the 4 mounting holes are shown below.
Setting the IP Address
The Ethernet TCP/IP configuration utility is installed as part of the Inview
Messaging Software package. When first opening the Inview Messaging Software,
you are asked to create a display and a message file. After the display is created
you can configure the IP address of the 2706-PENET1 module.
1. Select the display you created, which will use the Ethernet module. Right
click on the display and select Edit Display as shown below.
7.40 in (188 mm)
3.46
(88 mm)
Enclosure Case