Rockwell Automation 2706-PENET1 InView Ethernet TCP/IP Module - Manual (Page 9)

InView Ethernet TCP/IP Module 9
Publication 2706-IN008D-EN-P - October 2003
2. When the Edit Display window appears, go to the Communications tab.
This is where the configuration utility is located.
3. Under the section with the heading TCP/IP settings is the Configure
Communications button. By clicking this button you will be taken to the
Ethernet TCP/IP Communications window. This is where the IP address will
be set.
TIP
Double-clicking on the display will take you to the same
window.