Rockwell Automation 2727-MRJB1 MobileView Junction Box Installation Instructions - Manual (Page 4)

4 MobileView Junction Box
Publication 2727-IN006C-MU-P
Junction Box Dimensions
S1 RJ-45 jack for connecting the MobileView data lines.
S2 9-pin DSUB female connector (for future use).
S3 RJ-45 jack to Ethernet network.
X1 12-pin male connector for connecting the Junction Box Cable.
X2 12-pin male connector (shipped with a female block terminal connector) for
connecting the power supply, emergency stop switch, and enabling switches.
ATTENTION
!
The Junction Box and the MobileView terminal meet the safety
class III in accordance with EN 61131-2 and EN 50178. When
connecting the MobileView terminal, make sure all voltages
connected to the terminal are safety low voltages and isolated
from the low voltage supply system by a safety transformer or
a similar safety component.
24V D C
ON LY
TER M IN AL IN
R S422 OUT
ETH ER N ET O U T
+24V
GND
ES 1+
ES 1-
ES 2+
ES 2-
ED1 +
ED1 -
ED2 +
ED2 -
+24V
GND
ES 1+
ES 1-
ES 2+
ES 2-
ED1 +
ED1 -
ED2 +
ED2 -
X2
60 mm (2.36 in) 108 mm (4.25 in)
162
mm (6.4 in)
S1
S2
S3
X1
Grounding Screw
DIN Rail Latch
150 mm (5.91 in)
Strain Relief
(with Female
Pin 1, 24V dc
Pin 1, 24V dc
Terminal Block
Connector K4)
(with Female
Terminal Block
Connector K3)
Grounding Screw