Rockwell Automation 2727-MRJB1 MobileView Junction Box Installation Instructions - Manual (Page 5)

MobileView Junction Box 5
Publication 2727-IN006C-MU-P
Mounting the Junction Box on a DIN Rail
Mount the Junction Box on a DIN rail inside the enclosure.
To install the Junction Box on a DIN rail:
1. Mount the DIN rail.
2. Hook the top slot over the DIN rail.
3. While pressing the Junction Box against the DIN rail, snap the Junction Box
into position.
To remove the Junction Box from the DIN rail:
1. Place a screwdriver in the DIN rail latch at the bottom of the Junction Box.
2. Holding the Junction Box, pry downward on the latch until the Junction Box
is released from the DIN rail.