Rockwell Automation 2711P-RGxx Antiglare Overlay for PanelView Plus 400 and 600 Terminals - Manual (Page 6)

6 Antiglare Overlay for PanelView Plus 400 and 600 Terminals
Publication 2711P-IN022B-EN-P - October 2008
The antiglare overlay has a protective layer over the adhesive side of the overlay
which can be removed by pulling back on the tab.
Cleaning the Terminal
Use Windex™ or a similar glass cleaner to remove grease, fingerprints, streaks and
lint from the terminal screen. Any marks you do not remove will be trapped
underneath the overlay. Grease will also affect the adhesion of the overlay.
Attaching the Overlay
1. Grasp the tab and partially peel back the protective layer covering the
adhesive side of the overlay from one of the short sides.
Hold the peeled-back portion of the overlay protective layer out of the way
as you perform the next step.
TIP
DO NOT remove the protective layer until you are ready to install the overlay.
Protective Layer
Tab
Adhesive Ring
Overlay
Bezel
Protective Layer
(Covers Adhesive)