Rockwell Automation 2711P-RGxx Antiglare Overlay for PanelView Plus 400 and 600 Terminals - Manual (Page 7)

Antiglare Overlay for PanelView Plus 400 and 600 Terminals 7
Publication 2711P-IN022B-EN-P - October 2008
2. Center the antiglare overlay on the terminal and carefully position the
exposed adhesive surface on the terminal.
3. Slowly peel off the rest of the overlay protective layer, while using a soft
cloth to press the antiglare overlay on the screen.
Make sure that the overlay lies flat without bubbles or warps.
4. With the soft cloth or the flat surface of a fingernail, press around the edges
of the overlay to completely seal it and remove any air bubbles trapped in
the adhesion.
Remove the Overlay
If it is necessary to remove the overlay, lift up a corner and slowly pull the overlay
off. Use isopropyl alcohol to remove any residual adhesive.
Removing the overlay greatly reduces the effectiveness of the adhesive. We
recommend that you do not reuse the overlay.
Additional Resources
These documents contain additional information concerning related Rockwell
Automation products.
You can view or download publications at
http://literature.rockwellautomation.com . To order paper copies of technical
documentation, contact your local Rockwell Automation distributor or sales
representative.
Resource Description
PanelView Plus User Manual,
publication
2711P-UM001
Provides an overview of the PanelView Plus and PanelView
Plus CE terminals and gives information on how to install,
operate, configure, and troubleshoot these devices.
Wiring and Grounding Applications for
PanelView Plus devices Technical Data,
publication
2711P-TD001
Provides additional information on wiring and grounding the
PanelView Plus and PanelView Plus CE terminals.