Rockwell Automation 6181X-15xxxxxxx VersaView 6181X-IN001B-MU-P - Manual (Page 12)

12 VersaView 6181H Integrated Display Computers
Publication 6181H-IN001B-MU-P
5. Gradually tighten the clips one at a time around the bezel using the specified
sequence. Note that the sequence begins with the center clips and continues
to the corner clips.
Repeat this process at least three times until the clips are hand-tight and the
gasket is compressed uniformly against the panel.
6. Tighten mounting clips to a torque of 10 in-lbs (1.1 N•m) in the sequence
shown above. Do not over-tighten.
ATTENTION
Tighten mounting clips to a torque of 10 in-lbs (1.1
N•m) to provide a proper seal and prevent damage to
the computer. Rockwell Automation assumes no
responsibility for water or chemical damage to the
terminal or other equipment within the enclosure
because of improper installation.
1 10 9
2 7 8
5
4
3
6
Torque
Sequence