Rockwell Automation 2090-CSWMxxx Single Motor Cables with Circular DIN Connector Type 923 Install Instructions - Manual

Installation Instructions
Single Motor Cables with Circular DIN
Connector Type 923
Catalog Numbers 2090-CSBM1DF-14AA
xx, 2090-CSBM1DF-14AFxx,
2090-CSBM1DF-18AA
xx, 2090-CSBM1DF-18AFxx, 2090-CSWM1DF-14AAxx,
2090-CSWM1DF-18AA
xx
About Single Motor Cables
These single motor cables have an M23 SpeedTec connector at the motor end, and flying leads at
the drive end. These cables can be bent or reformed during installation or maintenance. The list
below describes the standard and continuous-flex operations for the cables:
•
Use 2090-CSBM1DF- xxAFxx cables in continuous-flex operations
(available only with brake).
•
Use 2090-CS
xM1DF-xxAAxx cables in standard (non-flex) operations
(available with or without brake).
Installing Single Motor Cables
Follow these safety notices when installing this cable between a servo drive and a motor.
Additional precautions are noted in the Kinetix Motion Accessories Specifications Technical
Data, publication
GMC-TD004 .
ATTENTION: Always remove power to the servo drive before connecting or disconnecting
cables at the drive or at the motor.
Arcing or unexpected motion can occur if the cable is connected or disconnected while power is
applied to the drive.
ATTENTION: Always ground the overall shield of the cable. Doing so improves system EMC/EMI
performance and helps to provide uninterrupted operation. Electrical noise can cause
communication signals to fail.
ATTENTION: Do not tightly gather or coil a cable that transfers power. Heat is generated within
a cable whenever power is applied and only an uncoiled cable can freely dissipate that heat.