Rockwell Automation 2090-CSBM1DF-10AF Single Motor Cables with Circular DIN Connector Type 740 Install Instructions - Manual

Installation Instructions
Single Motor Cables with Circular DIN
Connector Type 740
Catalog Numbers 2090-CSBM1DF-10AF
xx
About Single Motor Cables
Single motor cables have an M40 SpeedTec connector at the motor end and flying leads at the
drive end. These cables can be bent or reformed during installation and maintenance. Use the
2090-CSBM1DF-10AF
xx cables in continuous-flex operations (available only with brake
conductors).
Installing Single Motor Cables
Follow these safety notices when installing this cable between your servo drive and the motor.
Additional precautions are noted in the Kinetix Motion Accessories Specifications Technical
Data, publication
GMC-TD004 .
ATTENTION: Always remove power to the servo drive before connecting or disconnecting
cables at the drive or at the motor.
Arcing or unexpected motion can occur if the cable is connected or disconnected while power is
applied to the drive.
ATTENTION: Always ground the overall shield of the cable. Doing so improves system EMC/EMI
performance and helps to provide uninterrupted operation. Electrical noise can cause
communication signals to fail.
ATTENTION: Do not tightly gather or coil a cable that transfers power. Heat is generated within
a cable whenever power is applied and only an uncoiled cable can freely dissipate that heat.
IMPORTANT The feedback wire pair (Data+/Data-) requires a metallic feedback connector kit for proper
signal termination. Refer to
Additional Resources on page 4 for the installation instructions for
the feedback connector kit and other related publications.
The feedback connector kit is included with the servo drive.