Rockwell Automation 2100H-ECPxx CENTERLINE Motor Control Center End Closing Plates - Manual (Page 3)

CENTERLINE 2100 Motor Control Center End Closing Plates 3
Publication 2100-IN069A-EN-P - February 2009
About the End Closing Plates
The closing plates are for the right sidesheet of a Motor Control Center. They are to
be used if you have rearranged your LVMCC line-up so that a sidesheet with the
integral mounting flanges is on the outside of the line-up.
Catalog Number Explanation
This table explains what the catalog number represents.
Parts List
These kits come with the following parts.
Install the End Closing Plates
Follow these steps to install the end closing plates.
Catalog Number Description
2100H-ECP1A End closing plate kit (15 in. (381 mm) deep - NEMA Type 1 and 1 with gasket) for
sidesheet with integral mounting flanges
2100H-ECP2A End closing plate kit (20 in. (508 mm) deep - NEMA Type 1 and 1 with gasket) for
sidesheet with integral mounting flanges
2100H-ECP1J End closing plate kit (15 in. (381 mm) deep - NEMA Type 12) for sidesheet with integral
mounting flanges
2100H-ECP2J End closing plate kit (20 in. (508 mm) deep - NEMA Type 12) for sidesheet with integral
mounting flanges
Section Width Number of Plates Number of Thread Forming Screws
15 in. (381 mm) 3 (1)
(1) One plate is flat. Install this plate first, at the bottom of the sidesheet. Two plates have a formed edge. Install these plates
in the middle and top positions.
18 (6 per plate)
20 in. (508 mm)
3
(1) 27 (9 per plate)
SHOCK HAZARD
Disconnect all sources of power to the motor control center. Serious injury or death can
result from working on energized MCCs.