Rockwell Automation 2755 I-O Module Board and Connector - Manual (Page 5)

Bulletin 2755 I/O Module Board and Connector 5
Figure 2
Locknut
Washer Washer
I/O Connector I/O Connector
Locknut
Washer
I/O Connector
I/O Module Wiring Holes
Switch and Power
Connector Area
Locknut
This section shows how to wire the cables of the I/O Connector
(Catalog No. 2755-NB0) to the I/O modules. Refer to Figure 3
during installation.
Below each module position on the I/O board is a terminal block
connector which accepts up to 12 gauge wire.
To wire each output module:
1. Strip 1/4 inch of the insulation from cable wires (removing
wire particles).
2. Loosen terminal screws on pull-apart connector.
For easier installation, remove connector from the I/O board
by gently lifting the connector.
3. Insert wires into connector. Note polarity on module
connectors when installing DC modules.
4. Tighten terminal screws on connector to secure the wires.
5. Replace pull-apart connector (if removed from I/O board).
Wiring I/O Modules