Rockwell Automation 2711P-RAT12E Adapter Kit for PanelView 1400eTouch Screen Terminal Cutout - Manual (Page 4)

Publication 2711-IN023B-EN-P - November 2002 4 PN 41061-167-01(2)
Copyright © 2002 Rockwell Automation, Inc. All rights reserved. Printed in the U.S.A.
PanelView, PanelView Plus, Allen-Bradley, and Rockwell Automation are trademarks of
Rockwell Automation, Inc.
Trademarks not belonging to Rockwell Automation are property of their respective companies.
Attach the Terminal to Adapter Plate
1. Insert the new touch screen terminal into the adapter plate
cutout until the terminal gasket is flush with the front of the
adapter plate.
2. Install the mounting clips according to the Installation
Instructions of the new terminal. The ends of the clips slide into
the slots on the terminal.
3. Tighten the screws on the mounting clips by hand until the
gasket seal contacts the mounting surface uniformly.
4. Using the torque wrench, tighten the screws on the mounting
clips to the torque rating provided in the Installation Instructions
of the new terminal. Do not overtighten.
The new touch screen terminal is now ready for operation.
Mounting Clip
Screw Driver Slot
Mounting Slot
Mounting Slot
Adapter Plate
Screw Driver Slot
Mounting
ATTENTION
Tighten mounting clips to the proper torque to provide a proper seal
and to prevent potential damage to the terminal. Allen-Bradley
assumes no responsibility for water or chemical damage to the
terminal or other equipment within the enclosure because of improper
installation.