Rockwell Automation 9329 Drive Application Software Positioning Point to Point - Manual (Page 2)

Quick Start – Positioning (Pt to Pt)
Drive Application Software – page 2 of 10
Precautions
Class 1 LED Product
ATTENTION: Hazard of permanent eye damage exists when using optical
transmission equipment. This product emits intense light and invisible radiation. Do
not look into module ports or fiber optic cable connectors.
General Precautions
ATTENTION: This drive contains ESD (Electrostatic Discharge) sensitive parts and
assemblies. Static control precautions are required when installing, testing, servicing
or repairing this assembly. Component damage may result if ESD control
procedures are not followed. If you are not familiar with static control procedures,
reference Allen Bradley publication 8000-4.5.2, “Guarding Against Electrostatic
Damage” or any other applicable ESD protection handbook.
ATTENTION: An incorrectly applied or installed drive can result in component
damage or a reduction in product life. Wiring or application errors such as under
sizing the motor, incorrect or inadequate AC supply, or excessive surrounding air
temperatures may result in malfunction of the system.
ATTENTION: Only qualified personnel familiar with the PowerFlex 700S AC Drive
and associated machinery should plan or implement the installation, start-up and
subsequent maintenance of the system. Failure to comply may result in personal
injury and/or equipment damage.
ATTENTION: To avoid an electric shock hazard, verify that the voltage on the bus
capacitors has discharged before performing any work on the drive. Measure the DC
bus voltage at the +DC & –DC terminals of the Power Terminal Block (refer to
Chapter 1 in the PowerFlex 700S User Manual for location). The voltage must be
zero.
ATTENTION: Risk of injury or equipment damage exists. DPI or SCANport host
products must not be directly connected together via 1202 cables. Unpredictable
behavior can result if two or more devices are connected in this manner.
ATTENTION: Risk of injury or equipment damage exists. Parameters 365 [Encdr0
Loss Cnfg] - 394 [VoltFdbkLossCnfg] let you determine the action of the drive in
response to operating anomalies. Precautions should be taken to ensure that the
settings of these parameters do not create hazards of injury or equipment damage.
ATTENTION: Risk of injury or equipment damage exists. Parameters 383 [SL
CommLoss Data] - 392 [NetLoss DPI Cnfg] let you determine the action of the drive if
communications are disrupted. You can set these parameters so the drive continues
to run. Precautions should be taken to ensure the settings of these parameters do
not create hazards of injury or equipment damage.