Rockwell Automation 2711-K5Axx_B5Axx PanelView 550 Terminals Installation Instructions - Manual (Page 9)

PanelView 550 Terminals 9
Publication 2711-IN009E-EN-P - February 2009
Installing Terminal in a Panel
To install the PV500 terminal in a panel:
1. Cut an opening in the panel using the panel cutout provided with the
terminal. Remove sharp edges or burrs.
2. Make sure the sealing gasket is properly positioned on the terminal (as
shown below). This gasket forms a compression type seal. Do not use
sealing compounds.
3. Verify that the ends of the legend strips are secured with the legend strip
adhesive.
4. Place the terminal in the panel cutout.
5. Make sure the ends of the legend inserts are positioned behind the panel
cutout.
6. Install the six self-locking nuts, hand tight.
ATTENTION
•
Disconnect all electrical power from the panel before making the cutout.
• Make sure the area around the panel cutout is clear.
• Take precautions so that metal cuttings do not enter any components that may
already be installed in panel.
•
Failure to follow this warning may result in personal injury or damage to the
panel components.
Sealing Gasket Legend Strip Adhesive
Tape