Rockwell Automation 2706-PNR2 InView P22R Message Display Adapter Plate - Manual (Page 2)

Publication 2706-IN020A-EN-P - January 2004 PN 41061-345-01(1)
Supersedes Publication XXXX-X.X.X - Month Year Copyright © 2004 Rockwell Automation, Inc. All rights reserved. Printed in the U.S.A.
InView Display Mounting
The following instructions provide panel cutout dimensions for the InView P22R
Panel Mount Display.
The InView P22R mounts in a custom panel or enclosure. When it is properly
installed, the faceplate provides a NEMA Type 12, 13, and 4X(indoor) rating. To
install the InView Display:
1. Cut and drill the appropriate mounting holes in the enclosure or panel.
2. Remove the six mounting nuts from the hardware bag provided with the
display.
3. Position the InView Display in the panel or enclosure mounting hole.
4. Install nuts and alternately tighten the nuts to a torque of 0.904 Nm (8 in-lb).
Panel Cutout Dimensions
Cutout 345.9 (13.62)
Cutout
173.0 (6.81)
98.4
(3.88)
352.3 (13.87)
Cutout
88.9
(3.50)
176.3 (6.95)
4.8 (0.19)
4.8 (0.19)
6.4 (0.25)
Diameter
Hole
6 places
2706-P22R Display
All dimensions are in millibeters (inches)