Rockwell Automation 2727-T7P30D1F MobileView Tablet T750 User Manual - Manual (Page 59)

Publication 2727-UM001D-EN-P - March 2004
Communications Configuration 5-5
Power Save Mode Sets your client adapter to its optimum power-consumption
setting.
Options: CAM, Fast PSP, or Max PSP
Default: CAM (Constantly Awake Mode)
CAM: Keeps the client adapter powered up continuously so
there is little lag in message response time.
Consumes the most power but offers the highest throughput. Is
recommended for desktop computers and devices that use AC
power.
Fast PSP: Fast PSP (Power Save Mode) switches between PSP
mode and CAM mode, depending on network traffic. This
mode switches to CAM when retrieving a large number of
packets and switches back to PSP after the packets have been
retrieved.
Max PSP: Max PSP (Max Power Savings) causes the access
point to buffer incoming messages for the client adapter,
which wakes up periodically and polls the access point to see
if any buffered messages are waiting for it. The adapter can
request each message and then go back to sleep.
Conserves the most power but offers the lowest throughput. Is
recommended for devices for which power consumption is the
ultimate concern (such as small battery-powered devices).
WEP Enables or disables WEP for your client adapter.
Options: Enabled or Disabled
Default: Disabled
This parameter can be used in two ways:
•
If you set a WEP key using CEM, you must also select
Enabled for this parameter to enable WEP for your
client adapter.
•
If you enabled LEAP for your client adapter, this
parameter is changed automatically to Enabled, and
the RADUIS server assigns a dynamic, session-based
WEP key to the adapter.
Parameter Description