Rockwell Automation 2711P-RSACDIN AC Power Supply - Manual (Page 6)

6 AC Power Supply for PanelView Plus/PanelView Plus CE Terminals
Publication 2711P-IN005C-EN-P - March 2007
Install the Power Supply
1. Position the power supply module A on a 35 x 7.5 mm DIN rail B (A-B pt.
no. 199-DR1) at 30° angle.
The power supply must be mounted horizontally as shown.
2. Rotate the power supply module onto the DIN rail with the top of the rail
hooked under the lip on the rear of the power supply.
3. Press the power supply module down onto the DIN rail until flush.
Locking tab (C) will snap into position and lock the power supply to the
DIN rail.
4. If the power supply module does not lock in place, use a screwdriver or
similar device to move the locking tab down while pressing the power
supply flush onto the DIN rail and release the locking tab to lock the power
supply in place.
If necessary, push up on the locking tab to lock.
5. Connect the power supply wiring as shown under Wire the Power Supply.
WARNING
If you connect or disconnect wiring while the field side power is on, an electrical arc can
occur. This could cause an explosion in hazardous installations. Be sure that power is re-
moved or the area is nonhazardous before proceeding.
PanelView Plus
A
B
C
C
24 VDC
POWER SUPPLY
2711P-RSACDIN
POWER
24 VDC POWER SUPPLY
2711P-RSACDIN
POWER