Configure a dynamic ip address using windows 7 – Rockwell Automation 7000 HMI Interface Board Software Updater and Firmware Download Procedure User Manual
Page 11
Advertising
Rockwell Automation Publication 7000-QS002A-EN-P - October 2012
11
HMI Interface Board Software Updater and Firmware Download Procedure
Configure a Dynamic IP Address using Windows 7
1.
From the Start menu, select Control Panel>Network and Sharing Center.
2.
Click Change Adapter Settings, and double-click Local Area Connection.
3.
Under the General tab, click Properties.
4.
Under the Networking tab, scroll down and select Internet Protocol Version 4 (TCP/IP). Click Properties.
5.
Click Obtain an IP address Automatically.
6.
Click OK on the two open dialogs, and Close on the Local Area Connection Status dialog.
Upon completion, refer to
Download System Firmware to the HMI Interface Board on page 12
Advertising