Rockwell Automation 1440-ACNR XM ControlNet Adapter - Manual (Page 13)

XM ControlNet Adapter 13
Publication ICM-IN001A-EN-P - March 2009
Install the replacement adapter on the DIN rail as follows.
1. Before installing the replacement adapter, make certain the XM Bus
connector of the terminal base is fully retracted into the base unit.
2. Position the replacement adapter on the DIN rail. The hook on the
terminal base slides under the edge of the adapter.
3. Push down and in at the same time to lock the adapter to the DIN
rail.
If the adapter does not lock in place, use a screwdriver or similar
device to move the locking tab down while pressing the adapter flush
onto the DIN rail, and release the locking tab to lock the adapter
module in place.
4. Gently push the XM Bus connector into the side of the adapter to
complete the backplane.
5. Reinstall the XM module in the adjacent terminal base.
6. Connect the wiring to the adjacent terminal base.
7. Connect the ControlNet cable to the adapter.
Cont rolNet XM A dapter 1440-ACNR
XM ®
MS CHA CHB BPS