Rockwell Automation GMLC Installation Manual - Manual (Page 3)

Installing GML Commander 3
Publication GMLC- 5.3-CDI - March, 1999
Installing GML Commander
Your GML Commander software comes on either a single CD
ROM disc or a series of 3.5-inch high-density (1.4 MB)
diskettes. Either way, the software is a self-installing
executable file that you load on your computer’s hard disk.
Installing from CD ROM
When you insert the GML Commander CD ROM disc in the
CD ROM drive, the installation process automatically occurs if
your computer is configured for CD ROM autorun.
If CD ROM autorun is disabled through the Windows registry
on your computer, automatic installation will not occur. You
need to follow the procedures given below for manual
installation.
Automatic Installation
To automatically install GML Commander from CD ROM:
1.
Start Windows95 or Windows NT 4.0.
2. Insert the GML Commander CD ROM disc in the CD
ROM drive. The installation process automatically runs.
3. Follow the instructions shown on the installation program
windows to complete the installation process.