Rockwell Automation FlexPak 3000 Power Module SW-Version 4.3 - Manual (Page 62)

CHANGING PARAMETER VALUES
FlexPak 3000 49’1340 e 5-4
5.4 Selector Switch or Boolean Value Entry Screen
This screen allows the user to select one of two or several possible switch positions.
It is similar to a multi-position switch. The switch is changed by selecting a position
from a list of selections.
For example:
Speed/Voltage Loop (SPD) Feedback
FEEDBACK SELECT DC TACH
" ARMATURE VOLTS
DC TACHOMETER
PULSE TACHOMETER
AC TACHOMETER
!!
!!
Fault
Alarm
Interlock OK
Drive Ready
Running
Current Limit
Torque Limit
PROGRAM KEYPAD MANUAL FORWARD
1) Position the cursor to the line containing the desired switch position. This will be performed
using the
"
and
!
keys only. Scrolling will take place when applicable.
2) Press ENTER to accept the new value or press CANCEL to restore the original value and
then display the current value entry screen.
5.5 Reference Selecting via Keypad OIM
To select the reference via Keypad OIM, Control source select must be set to Keypad
The reference can then be altered using the
"
and
!
keys. Pressing ENTER stores the new
reference value.