Rockwell Automation 1442 Eddy Current Probe System - Manual (Page 28)

28 Rockwell Automation Publication ICM-UM004C-EN-E - February 2014
Chapter 1 Installation
Figure 3 - Sensor Mounting Bracket Installation Example
Use a Stinger
1442 Series 8-mm reverse-mount probes can be used with commonly available
probe holders. Stingers (also known as sensor sleeve), are provided with the probe
holder. Stingers can also be purchased from probe holder suppliers or can often
be machined locally.
The following instruction is a general guide based on common probe holder
designs. Consult your specific probe holder installation instructions for
additional details.
1. Remove the jam nut of the reverse mount sensor. (Remove at the Jam nut
attachment.)
TIP Install the probe holder and stinger assembly per installation instructions
before mounting the probe onto the stinger.