Rockwell Automation DC3R Isolation Option Board - Manual (Page 16)

10
Calibration
ATTENTION: The following adjustments are made with power on. Exercise
extreme caution as hazardous voltage exists. Failure to observe this precaution
could result in severe bodily injury or loss of life.
ATTENTION: The control circuit is at line potential when the drive is
energized. Use a non-metallic screwdriver when making adjustments to the
circuit board potentiometers. Exercise extreme caution as hazardous voltage
exists. Failure to observe these precautions could result in severe bodily injury
or loss of life.
ƽ
All adjustments increase with CW rotation, and decrease with CCW rotation. Use a
non-metallic screwdriver for calibration. Each trimpot is identified on the printed
circuit board.
Figure 9. Calibration Trimpot and DIP Switch Layout
SIGNAL
INPUT ADJ.
SIGNAL
INPUT DIP
SWITCHES
MIN
OUT
MAX
OUT