Rockwell Automation T3404 ICS Regent AC Digital Input Module 110 VAC - Manual (Page 11)

(T3404) AC Digital Input Module
P D - 6 0 1 3 M a r - 0 6
11
Table 1. Slot Key Positions.
Module Upper
Connector
Lower
Connector
T3404 17 15
Configuration
Each input module is configured using the W INTERPRET I/O
Configuration Editor. In the editor, you will perform the
three steps described below to configure the input module.
1) Set the Module Type:
Position the cursor on the module slot you wish to define.
Choose Set Module Type from the Edit Menu and select
the appropriate digital input module from the list.
2) Edit the Module Definition:
Choose Edit Module Definition from the Edit Menu. A
dialog box will open where you can define the input point
definitions.
Figure 8. Digital Input Module Definition.
3) Edit each point:
Choose Edit from the Module Definition dialog box to
define a name and description for each I/O point. In the