Installation – Rockwell Automation T812X Trusted Processor Interface Adaptor User Manual
Page 12
Advertising
Trusted
TM
Process Interface Adaptor T812X
Issue 8 Sep 07
PD-T812X
12
2. Installation
Figure 3 Correct Installation Position
The adapter should be fitted on the rear of the chassis behind the processor slots, as shown above.
The two connectors should fit into the third and sixth slots from the right, where the processor
connectors will fit. In the correct position, two empty slots will be visible on the right. Insert the adapter
into position about 5mm lower than its final position, and ensure it is slotted in on both sides. Raise the
adapter upwards until the retaining clips click into place.
Advertising